Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Vintage TV & Radio Tech Forum

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 11-06-2013, 06:41 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Take a look at the Sarkes Tarzian Selenium rectifier databook - most seleniums have about a 5V drop across them, and a bit lower when leaky.

Assuming a 5V drop, your 320ma (from an earlier post), and you have your two variables needed to get started. A silicon diode (1n4004/5/6/7 series) drops approximately .7V, so you need to drop the other 4.3V.

For your series resistor, R=E/I, so 4.3, divided by your current 320mA = 13.5 ohms, roughly. Power is as easy as P=I X E, so 320mA X 4.3V = 1.5 Watts, better to upsize it to a standard wattage. I'd go with a wirewound, as most filament resistors of yore are wirewound:

http://www.talonix.com/images/RESPFIL.jpg

I'm surprised there isn't more info (reliable, that is) about replacing seleniums on the web. We used to replace them all the time when I worked for my dad - even attached a new schematic for the next tech, so he'd know what he was dealing with. My least favorite swap was in a Nutone intercom for a dentist - the selenium was buried under a multi-station switch, with little room, and harly any room to mount the resistor. We went with a chassis mount, and used a resistor only a watt above the calculation. Solid state intercom, but it had a selenium rectifier - go figure!

Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:25 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.