Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 10-02-2013, 04:47 PM
TinCanAlley's Avatar
TinCanAlley TinCanAlley is offline
VideoKarma Member
 
Join Date: Sep 2008
Location: So Cal, CA
Posts: 1,026
Quote:
Originally Posted by Username1 View Post
Who makes your dmm, where did you get it, and how much$.

The pins at the horiz board, tp5 is 123, next one down is 124, and bottom is 6. The schematic you posted is not that clear, and gets worse when I blow it up, so If you check the voltages at each one of these points, are they correct, higher, lower?
You need to post "posted" value as in (sams) and actual, (what you read), How DMM Scope.

How about the wave form at the base of the HOT? is it good?

The diode, and cap in the collector circuit closest to the HOT on the schematic? they good?

Does the schematic detail the meter used ? for sams voltage readings?
My DMM is a Craftsman and is about 13 yrs old. (See pic)

I will check those other points and post their voltage and the Sams voltages.

I was told that the diode on the HOT had to be good since the HOT would be dead if it wasn't. As for the capacitor, I didn't test. Can I use an ESR meter to test it? I believe if I pull the hot, I should be able to test that capacitor without disconnected a leg an it should be pretty much isolated at that point.

I will put the set on her side and remove the bottom to get the waveform of the base of the HOT.
Attached Images
File Type: jpg DMM Pic.jpg (62.9 KB, 5 views)
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL

Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:29 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.