Problem replacing screen taps with pots

[zeno]

5K should work fine, its an easier value to find than a 4 K
unless I am wrong ! The adjustment just wont be quite as precise.
Looking at the schematic the wiper(center) goes to the "plug" wire (CTR).
One end goes to C of video out.
Other goes to JCN of R239 & R238.

If you dont take out R239 & R240 they are in parallel with
the pot cutting the ohms in half & reducing range.
1)Nip off R240 at the C of Q206
2) hook up only the wire to CRT to center of pot.

If you nip the R deep in the TS you can tack it back on
& nobody will ever know if you change it back.

73 Zeno