![]() |
|
#20
|
||||
|
||||
|
Well I went ahead and wired in the 523, it works, that is it makes HV and doesn't explode but I'm concerned about how much HV.
Not wanting to damage the CRT I did the the power up with the 2nd anode hooked to my HV probe, but not connected to the CRT, it has 36kv ! Seems a tad high for a 17" set, or even a 25" set. Of course there's no load on it other than the probe so maybe it's OK, or maybe I have a bad safety cap? I think I will replace the Safety caps before going any further. |
| Audiokarma |
| Thread Tools | |
| Display Modes | |
|
|