Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #6  
Old 08-03-2013, 12:56 PM
TinCanAlley's Avatar
TinCanAlley TinCanAlley is offline
VideoKarma Member
 
Join Date: Sep 2008
Location: So Cal, CA
Posts: 1,026
I think I'm going to do the following.

Put shrink tubing on the negative leads (about 1/2" of tubing)
Twist bare negative leads into a single lead and solder
Shrink tube negative lead leaving enough exposed to solder to a ground point
Shrink tube positive leads leaving 1/2" of lead exposed of each
Remove the wire leads from the canister and slide 2" of shrink tubing over each lead (not shrinking yet)
Solder wire leads to cap leads
Slide shrink tubing previously put on wire over solder joint and shrink tubing
Insert a board standoff in empty hole near to canister
Wire tie cap bundle to standoff

Of course this might not go exactly as noted, but it seems like a logical approach and should be safe and tidy. The shrink tubing should cover leads from body of cap and all soldered connections. There shouldn't be any exposed metal to short.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL

Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:44 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.