Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #27  
Old 07-19-2013, 09:43 AM
dtvmcdonald's Avatar
dtvmcdonald dtvmcdonald is offline
VideoKarma Member
 
Join Date: Nov 2012
Posts: 1,268
The hum problem was two bad 6AU6s in the IF chain. There still was hum
in the vertical sweep from inadequate filtering in the B- supply. The
original "100 uF" filter cap measured 160 uF, the new one, right at 100 uF,
so I paralleled it with another 100uF, and it is much improved.

Also ... this set appears to be a slight hybrid of the Rider's (1948) and
Sam's (1949) designs. In particular, the vertical sweep output feedback is
Rider's while the rest is mostly Sam's. Since the (dogbone ceramic) capacitors in this
circuit were very low (.001 uF rather than .0015) I tried the Sam's circuit
and it works much better. The previous owner replaced the 3000 kV .005 uF paper
vertical sweep with .0033 uF ceramics, which is too low. .005 uF is too low too,
so I'm ordering up 4 .01 uF 6 kV ceramics to get .02 uF. These are not cheap.

Other than the vertical sweep problems, it now generates a very nice picture.
I'm going to try an alignment using my proposed non-sweep method:
using Comcast digital as a source, a spectrum analyzer to look at the
output, and a nice synthesizer as marker generator. It may not need alignment
since it seems to work OK.

Doug McDonald
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:55 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.