Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #12  
Old 07-16-2013, 02:07 AM
ppppenguin's Avatar
ppppenguin ppppenguin is offline
VideoKarma Member
 
Join Date: Oct 2009
Location: London, UK
Posts: 466
In theory a pair of identical electrolytics will tend to balance the voltages across them fairly well due to leakage and the way the insulating layer is formed by the application of voltage. In practice as others have observed it can go badly wrong, especially if one cap dries out. I'd probably use bleeds even if this wasn's strictly needed. What value bleeds? The current needs to be large compared to leakage and small compared to what's being supplied to the load. This is total guesswork but I'd probably bleed about 1% of the load current.

If you are using non-electrolytics in series to increase the voltage rating then bleed resistors are essential. The problem in some case may be finding high enough values to keep the wasted current down. For example if you replace a 100n 5kV cap in a TV with mains EHT using 10x 1u 630V then 10M resistors will draw 50uA. This may be excessive.
__________________
www.borinsky.co.uk Jeffrey Borinsky www.becg.tv
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:50 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.