Watch out for mice.....OMG!!!

[Kamakiri]

Originally Posted by holmesuser01

I'd be checking for drive from the oscillator, B+ on the output tube, the damper circuits. Could easily be something like an open resistor... Is the yoke OK, too? Does the horizontal output actually get HOT, other than filament hot? So many possiblilities!

I think the schematic would be something worth getting at this point, for sure.

It's not hotplating, if that's what you mean.....

And yep, gonna definitely need a schematic now.

[holmesuser01]

Originally Posted by Kamakiri

It's not hotplating, if that's what you mean.....

And yep, gonna definitely need a schematic now.

Yes. I assumed you would have told us if it was red plating, anyway.

You'll get it going!

[Kamakiri]

I pretty much have to now!

I knew there'd be a little adversity with it, though. After all, the best laid plans of mice and men......