|
|
|
#11
05-29-2013, 02:02 AM
|
||||
|
||||
|
Ohh, so that is what those strings are! I thought they were junk (like the pieces of HV wire some tech left) and tried to yank them out....Good thing I failed to yank them off. I probably messed up the settings when I pulled on them. If they are all the way back is there a way to get them forward?
Service switch kills ALL light on the screen so I did the screen adjustments by pulling one of the vertical wires to the yoke. It was off center(too high) when I did that so I guess I shouldn't have yanked those strings. I'll have to look up the datasheet for the vertical output tube or get the sam's to find the cathode pin. By "B+ and load resistors" do you mean in the PS or vertical circuit?
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode