Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #12  
Old 05-10-2013, 10:53 AM
zeno's Avatar
zeno zeno is offline
VideoKarma Member
 
Join Date: Mar 2013
Location: New Hampshire
Posts: 4,918
You may have your grounds mixed up. There are 2 grounds.
One is for the power supply primary. Measure across the large
cap on the right side in photo above your black lead. Should
be abt 150 V BTW this gnd is hot. If its low the cap may be going.

For the cold ground use the tuner shield. This is where you
measure almost everything else. Using this ground measure & set
TP4 for 130V.
This will be the same on almost any CRT TV without a real power transformer. Also keep in mind the CRT dag probably dosnt go to ground like most NAP sets of this vintage !

This was probably the last decent NAP chassis built.
They had some flybacks go, supply wiped out by lightning &
I think SAW filters but not much else.
When done also look for cold joints from the hoz drive through
the HV you will find some on almost every TV made.
BTW put up a screen shot if you dont get anywhere.

73 Zeno
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:50 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.