Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 04-28-2013, 01:52 AM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
I've completed recapping on the Horizontal/High Voltage section, the entire horizontal sweep section is inside the big cage.
Four multi section electrolytics, all with lots of connections to them made it quite a chore, there are four more cans on the i.f. chassis as well but for now this is enough to test for high voltage, really high voltage, more than a 21" Color Roundie!

Both of the 6BG6's in this set were weak, I found a couple good ones and replaced them, the metal 6AC7 Horiz AFC looked totally fried and checked dead as a doornail, though I could feel the heater getting warm, found a good used one to replace that.

First I had to hook all the chassis together, plus a resistor pack, the switch and the interlock switch.

First attempt on the Variac, two of the 5U4's on the PS aren't lighting up, wiggled them around a bit and they came on (note to self, clean the sockets).

Second attempt, getting a couple thousand volts at the Anode but two of the three 1B3's I picked at random from my stash are lighting up purple, replaced them with three, brand new, Russian made 1B3's from the case of 50 I bought a decade ago.

Third attempt, success, though I can hear something arcing down in the cage, I'm getting 28k (or darn close) at the second Anode! (note to self, don't slip and touch the Second Anode )

On the Cabinet front, I got the base reassembled and glued the connecting section back to the main cabinet, I haven't joined the main cabinet to the base yet because I want to stain and tone the base first.

This was in much worse shape than I first thought, lots of delamination on the sides, the veneer on the top will need replaced, the veneer on the sides may be repairable or I will replace it all whichever is easiest, the fortunate thing is all the book matched crotch-wood on the front is in good condition, a few cracks here and there but they won't show.

I reflowed the Lacquer on the control panel, it still has some issues so I will attempt to improve it some more. Basically I just poured Lacquer Thinner all over it, brushed it around and and let it soak, it clarified it greatly but there is some grit and bubbles in it so a second try is needed.

There is supposed to be a Mohawk dealer near me so I need to take a drive over there and see what Toners they have, it would be much easier in person that trying to figure out what color I need over the Internet.
Attached Images
File Type: jpg 28kv.jpg (65.6 KB, 49 views)
File Type: jpg cabinetreassembled.jpg (61.8 KB, 51 views)
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:11 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.