My 630

[Geist]

Hi All;
Old Coot, The Cap C220C is wired Correctly, Thank You for the clearification..
I have (for now) a wire connected to the 5U4 Pin 8 which goes to the meter.. Pin 8 is also connected to C221A, C220A, C220C, as well as the field coil, which connects to C221B at present and with one rectifier tube in gives a voltage of 230 Volts.. I had at first nothing connected to the 5U4, but right after checking that I connected back C221A and after working my way thru the field coil connections It also was then connected, along with the related caps.. So I didn't connect in the 10MFD 350 volt cap, since I had the others in.. I had only suggested it as a sub for C220C if it was backwards, which it is not..
At present the Centering pots and the focus coil are not connected to it.. I have not measured the Resistance in them, yet, But I can do that after I finish this posting..
I have been trying to work my way thru each wire and each section one at a time.. I have at present as stated above 230 Volts and that is without the focus coil and the Resistor dividers and the Centering pots..
I next want to put in C222A and make sure it is OK, I also will put in the Second Rectifier tube to see if the Initial voltage coming out of the Tubes will increase with the addition of the second tube.. And then I can see what I can do with C225A and C225B..
THANK YOU Marty