Scopes

[Geist]

Hi All;
Bandersen, I didn't see your reply till now.. The main reason for doing this is to get the part somewhat closer to what its correct setting should be.. Since as I have stated in other postings, everything and I mean everything in the 8T243, is not right.. And as you have stated, these parts all depent on each other and each part being somewhat correct.. The pots would not need to be taken out, but the measurement in one would be a starting place for the other.. Its mostly coils, like Horiz Lin, Width, etc.. that If put in the 630, after I get the 630 going correctly, then taking like the Width coil out of the 8T243 and temporially putting it in the 630, as everything else in the 630 would already be adjusted.. And the Width coil could then be made to work in the 630 or close to working.. it could then be put back in the 8T243 as a starting place for its final tweeking.. Also, when the circuit is the same or Similiar, I would have a scope on each one doing a comparison, section by section, tube by tube, etc.. Looking at what the RCA Service notes shows for each set, at a particular point.. Remember, these sets both use the same CRT, and much the same, circuitry.. Its not like comparing a Motorola to a GE.. I think it like comparing an apple to an apple, just a slightly different derivitive, like Jonathan to Macantosh..
THANK YOU Marty