![]() |
|
|
|
#1
|
||||
|
||||
|
Changing that cap might help, my tester had a few caps go bad and it works much better after changing them. If anything, it can't hurt it any to change it.
__________________
My TV page and YouTube channel Kyocera R-661, Yamaha RX-V2200 National Panasonic SA-5800 Sansui 1000a, 1000, SAX-200, 5050, 9090DB, 881, SR-636, SC-3000, AT-20 Pioneer SX-939, ER-420, SM-B201 Motorola SK77W-2Z tube console McIntosh MC2205, C26 |
|
#2
|
||||
|
||||
|
Is there any setting you can make (line adjust maybe?) that will move the needle on the meter past the point in question? I'm wondering if the meter movement is mechanically obstructed at that point by a bit of dirt or something...
|
|
#3
|
||||
|
||||
|
Quote:
Thanks! |
|
#4
|
|||
|
|||
|
Quote:
The Mighty-Mite checker is one of the better small emission checkers out there, but it is still only an emission checker. IIRC, they tie all the elements together and check the tube as a rectifier. They were good for weeding out the real weak or dead tubes. Also for leakages or shorts. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|