Marconi Mark iv

[XDCAM]

Can Somebody please tell me the wiring of the Pulse/Blanking Cable for the CCU input please ?

[XDCAM]

I hope this went to one of the members !http://www.ebay.com/itm/1958-MARCONI...-/330792222659

[Telecruiser]

Originally Posted by XDCAM

I hope this went to one of the members !http://www.ebay.com/itm/1958-MARCONI...-/330792222659

I sure wish I'd known about it. I would have paid considerably more than the winning bid.

[XDCAM]

Originally Posted by Telecruiser

I sure wish I'd known about it. I would have paid considerably more than the winning bid.

At closer look it is a carcass .If I was you, I would make contact with this seller as he deals in Old Gear .

[Telecruiser]

Originally Posted by XDCAM

At closer look it is a carcass .If I was you, I would make contact with this seller as he deals in Old Gear .

I have sent him a message, but so far, no reply.

[XDCAM]

Does anybody kown the difference between the Vidicon CCU/Power Supply (Looks the Same) as the MkIV Image Orthicon 4.5 inch set please .Just Rescued these from being dumped .

[XDCAM]

Does Anybody know of a Camera Head that is (Beond repair) Parts .Looking for a Camera Door Cable Side .

[Paul B]

Hi all looking to bye a MK IV camera head / chain to go with my MK VII
also looking for MK VII Power Supply to get camera working also looking for lotes of good luck regardes Paul B

[ppppenguin]

Originally Posted by XDCAM

Can Somebody please tell me the wiring of the Pulse/Blanking Cable for the CCU input please ?

I assume you mean the EP8 pulse connector that Marconi often used on their kit. Paul Marshall is the man to give an authoritative answer but I think it's:

Pin 1: Line (Horiz) Drive
Pin 7: Field (vert) drive
Pin 5: Mixed blanking
Pins 3 & 8: Ground

Other pins unused. Mixed sync has its own PL259 conenctor.

[XDCAM]

Originally Posted by ppppenguin

I assume you mean the EP8 pulse connector that Marconi often used on their kit. Paul Marshall is the man to give an authoritative answer but I think it's:

Pin 1: Line (Horiz) Drive
Pin 7: Field (vert) drive
Pin 5: Mixed blanking
Pins 3 & 8: Ground

Other pins unused. Mixed sync has its own PL259 conenctor.

Thanks for the info .I don't have any paper work on this .

[XDCAM]

Originally Posted by ppppenguin

I assume you mean the EP8 pulse connector that Marconi often used on their kit. Paul Marshall is the man to give an authoritative answer but I think it's:

Pin 1: Line (Horiz) Drive
Pin 7: Field (vert) drive
Pin 5: Mixed blanking
Pins 3 & 8: Ground

Other pins unused. Mixed sync has its own PL259 conenctor.

Thanks