Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #4  
Old 09-06-2012, 02:04 PM
Kevin Kuehn's Avatar
Kevin Kuehn Kevin Kuehn is offline
Workin' Late Again
 
Join Date: Jan 2011
Location: WI
Posts: 3,976
Hi,

I think the control you're referring to is the Sync Stabilizer(marked SYNC STAB on the chassis). It's also sometimes referred to as the noise limiter control. That control adjusts the signal to noise ratio of the sync pulse going to the vertical and horizontal sync circuits. Generally you adjust it until overloading is observed in the picture, then back it down until overloading disappears. Sort of works in conjunction with the AGC control.

Agree with Eric, all paper and electrolytic capacitors should be replaced. A bit of a chore on those sets because of the limited access to the back side of the printed circuit boards.

Last edited by Kevin Kuehn; 09-06-2012 at 02:11 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:49 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.