![]() |
|
|
|
#1
|
|||
|
|||
|
You can use a transformer with a 6.3V winding and either retrofit different tubes (I don't recall the setup) or add a little 6.3V transformer to raise the voltage. There are many ways to do the job.
|
|
#2
|
|||
|
|||
|
Quote:
Heath used 12 volt tubes so they could use their beloved 12A6, as an audio output. They used that tube for everything, even as a rectifier.
|
|
#3
|
||||
|
||||
|
Quote:
Always was curious why they used that type as an output, and not a 6V6 or some more common type for that, but I can't really complain that they did.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#4
|
|||
|
|||
|
Quote:
|
|
#5
|
|||
|
|||
|
Quote:
The 211's were sold for less than $1.00 each.
|
| Audiokarma |
|
#6
|
||||
|
||||
|
Quote:
What are 211's BTW?
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#7
|
|||
|
|||
|
Quote:
They weren't used much in production equipment. RE: the 211's they're using them in those pricey, Chinese built SE mono-block amplifiers, that are sold today. They were common in WWII, surplus transmitters. |
|
#8
|
||||
|
||||
|
Heathkit GR-64 Transformer
HI:
Excuse my neophyte question, but I've seen posts before in the forum where folks have suggested rewinding power transformers. I've seen the inside of many over the years, and all look impossible to rewind due to the lamination of the core being enameled/glued. That enamel looks pretty sturdy. How does one get the iron plates apart without destroying them? I assume that step would require some sort of solvent, but what would you use that would not damage plastic or phenolic coil form parts? Would the rewind have to destroy all the wire in all windings to get the enamel off. Does heat work? Thanks! |
![]() |
| Thread Tools | |
| Display Modes | |
|
|