Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #6  
Old 08-20-2012, 09:48 PM
N2IXK's Avatar
N2IXK N2IXK is offline
Technohippie
 
Join Date: Apr 2011
Location: Sittin' on the "Group W" bench...
Posts: 817
The unused pins on vacuum tubes can be designated as either IC (internal connection) or NC (No Connection).

NC means exactly that--nothing inside the tube is connected to this pin. The circuit designer is usually free to use an NC socket terminal as a tie point for component support.

A pin marked IC or "Do Not Connect" is usually connected to "something" internally (typically used for physical support of the internal elements in some way). Exactly what (if anything) is connected to these pins can change with tubes of different manufacturers (who may use different structural arrangements for the same tube type) or even with different revisions of the same tube design from a single manufacturer.

In the specific case of HV rectifier tubes, the tube manuals will tell you which pins are "usable for wiring at or near filament voltage". These pins were occasionally used for a series filament resistor when a single turn on the flyback didn't produce enough voltage, but a second turn produced too much. A current limiting resistor in series with the CRT anode lead was another possible use for these pins.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:51 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.