![]() |
|
|
|
#1
|
||||
|
||||
|
Heres how the 10BP4 mounts on my RCA...
Steve |
|
#2
|
|||
|
|||
|
ha i got the same chassis on one of my side benches its out of 49-50 rca victor use's the 12Lp4 TUBE its been a project i pick around on every once in awhile, its been all recaped and i restuffed the large can caps on # c4 one of replaced caps after stuffing is a 10 mfd 450v on mine it runs hot every other cap is nice and cool on the chassis .its connected with vert output trans and yoke i thought it just might be a cheap miec cap tried another samething i clipped in a 20mfd 450v its ok runs normial , i checked the resistance of the yoke and vert output trans, the output trans shows lower than it should ,i havent realy devoted alot of checkout time with this chassis just wondering have you had any similer problem with yours. i probley should try a different manufacture of caps a 10mfd 450 before i do anything more just in case i have a problem with the lot 10mfd i have ,mybe there realy 250v and there marked 450v.
Last edited by snelson903; 07-07-2012 at 04:17 AM. |
|
#3
|
|||
|
|||
|
Thanks for the pics guys. Had not noticed the hot running caps, but good to know. If you have one a cap tester that can test for leakage at rated voltage and power factor or ESR may be a way to look into those caps. I always check the new caps that go into sets, I do not really trust a lot of the stuff that comes out of China, I sometimes wonder about the quality control, but since they seem to be the sole source for most everything you have to buy and check. Its one of the reasons I do not rush right out and replace all the cans anymore. I have found that often the existing cans work fine. Prob 1/2 or more of my mid 60's sets have the orig Mallory cans and work fine. I DO recommend fusing the B+ right before the 1st doubler or filter, regardless of new or old caps. Its seems logical since that (Ecaps) is the only place where there is a chemical product in the set.
I am going to have to study this for a while (the CRT mount) I def want it attached to the chassis so I can flip it on its side and be able to work on it. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|