![]() |
|
|
|
#1
|
|||
|
|||
|
ok after getting done with the tube bezzel ,i realy didnt like it so sandblasted down to bare metal and used filler primer and wet sand with 400grt and repainted it ,im now satisfied . you would not believe the time invested making that right it looks easy to paint but that small part shows up every little thing and the corners where a pain.
Last edited by snelson903; 06-30-2012 at 01:08 PM. |
|
#2
|
|||
|
|||
|
now the cabinet just had to apply 2 coats of stain let sit for 2 days then wip down then i sprayed polyurithane wait 24hrs sand with 400grt/520grt and spray on second coat its all dry now and finished i also installed the bezzel to get a look of how it turned out.the legs are finished i just need to find or make a botton for one of the legs . i went back and looked at the first picture of this tv ,what a change once i put the bezzel in now its starting to look like a tv again.
Last edited by snelson903; 06-30-2012 at 02:36 PM. |
|
#3
|
|||
|
|||
|
has anyone ever sodablasted a chassis before ,i here using baking soda as a meda would polish my chassis and not hurt anything else.
|
|
#4
|
|||
|
|||
|
i can say for myself im happy the way it turn out ,especially for my first time of doing one i have allready bought some real wood working tools instead auto body tools ,i think i found something else i like to do along with working on the electronic part of the tv im going to be looking for somemore turds in the future i know i can get next to nothing. im going to finish the tuner face and install that and show the cabinet comeplete, then im to start a new post doing the chassis and see if i cant raise the dead.thanks for all the complements from everyone ,i know i will be looking for some parts for the chassis so if anyone has any doner parts let me know 24mc32 thanks
|
|
#5
|
||||
|
||||
|
Very nice job. Hope the electronics come out the same.
__________________
Tom Smrz |
| Audiokarma |
|
#6
|
|||
|
|||
|
i hope i dont come up short on some parts i need ,and i grind to a halt the most time comsuming is the rust to remove without to much disasembly ,id like to get as much cleaned off before i take it down the basement.
Last edited by snelson903; 07-02-2012 at 03:26 AM. |
|
#7
|
||||
|
||||
|
Quote:
The Magnavox bezel I have was some sort of plastic composition painted gold. It's cool that Zenith made them in metal!! That was a lot of work, looks awesome. Magnavox300 |
![]() |
| Thread Tools | |
| Display Modes | |
|
|