![]() |
|
|
|
#1
|
||||
|
||||
|
I used a few places like PTS in the past. The repairs were usually pretty inexpensive, so it can't be that involved.
If you put one of those 7 and 9 pin socket extenders under your tubes, you can measure voltages and resistances. Not much to go wrong, maybe solder connections, feed-thru caps shorted, resistors etc, but to get IN there and actually replace a part, paying strict attention to lead dress could be like watchmaking. Turret tuners should not be big deal but wafer jobs are hard to get into. I usually saved good tuners on sets I scrapped, what do you have? |
|
#2
|
|||
|
|||
|
Fuzzy picture
I think I might have open or shorted caps(58 sylvania 21" set) Would like to find a good used or rebuilt replacement tuner?
|
|
#3
|
|||
|
|||
|
does it get better if you move the tuner around to find a sweet spot? there can be a lot of things that cause picture problems. Posting a pic would help.
does the fine tuning do anything? |
![]() |
| Thread Tools | |
| Display Modes | |
|
|