Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #9  
Old 06-19-2012, 11:31 PM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
It was around '99 when Philips/Magnavox TV's really started going down the toilet. Previous models were not bad sets. We had a circa 1982 19" Magnavox that was on more than it was off. We used it up until around '94 when the CRT became too weak to produce a watchable picture.

The RF connectors on most TV's from the '90's on up were not attached very well and it does not take much effort to rip one clean out of the tuner. I can't tell you how many TV's I've fixed that would either fall over while the cable was still connected or people would forget to disconnect the cable before moving the set and the result is that the RF connector gets ripped out. Personally, I've never done that because I never had any of my TV's sitting in a position where they'd fall and I've never forgotten to disconnect the cable before moving a set.

Those connectors are lightly crimped on from the factory. When I replace one, I solder it to the tuner. They'll do some major damage if they rip one out after I'm done with it. I've had a few where the tuner would become damaged beyond repair when the connector was ripped out; but, I've been able to fix a good many of them.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:39 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.