![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
I have the owner's manual for the 400, which is basically the same unit except for the meter shape. (The 420 went to a different circuit.) None of the early B&K manuals include a schematic. The one 350 that I've seen and some of the 400's were often found with burned resistors. Of course on a unit this old, both capacitors should be replaced and the one tube checked before using. I agree with the others, don't use the rejuvenation button on the 350 or 400 unless you want to risk killing the CRT. Other than that, these old units work very well on pre-mid-1950's CRTs and I really like how they enable you to quickly compare two tubes when you don't have a working set to use. I have added a copy of the 400 instructions. I don't have the original tube list, but all that it told was the filament voltage. If the tube would fit the only socket the tester had, and it was 1950s or earlier, it could be tested. The tube list in a below post is only for much newer B&K (higher number) CRT testers. James. Last edited by earlyfilm; 06-14-2012 at 12:52 PM. Reason: Clarification and to add manual |
|
#2
|
|||
|
|||
|
I love my 400 and 445. I only use to test CRT function and quality of course, but their great for burning in a long unused CRT, or bumping the filament voltage for an 'awakening' session. I keep one on the shelf and one in the trunk of my car for the occasional surprise find while on the road.
|
|
#3
|
||||
|
||||
|
James, how many pages is it? I don't want you to go to too much trouble. This is what I found on the net last night. Do you think these instructions will work?
http://www.bkprecision.com/downloads...etup_Chart.pdf Steve |
|
#4
|
||||
|
||||
|
Thank you so much for adding that PDF for me. I've saved it and will print it out when we're ready to test the pic tube. Steve
|
|
#5
|
||||
|
||||
|
I found a B&K model 440 today for 10 bucks and bought it. It has a tube chart with my pic tube in it but no instructions. Can I used the 350 instructions in the PDF you attached and be safe or do I need the 440 instructions to conduct the tests I need to to find out if my pic tube is good?
Thx! Steve |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|