|
use the diode test of a DMM. transistor is Emmiter Base Collector. the base is in the center. with a diode test clip check the EB then the CB one way it should read about .6v reverse the polarity of the leads and check again, it should be 0v
the polority of the leads will be different on NPN vs PNP type transistors, it does not really matter only that one way its .6 the other is 0
After check the EB and the CB check the EC, should be 0v reverse check again should be 0v.
You may find the voltage around .3v if so it just means its a germanium not silicon. Also this test is good for smaller signal transistors, large power transistors may not test the same.
all the testing must have the transistor out of the circuit, which is easy on the zenith if they are in sockets. Maker sure you put them back in the way they came out, the Emitter and Collector are not interchangeable.
|