![]() |
|
|
|
#1
|
||||
|
||||
|
You may look for a capacitor from the 3rd If or video detector to the sync circuit that goes leaky (hope I remember that correct), but I fought one of those chassis years ago for a long (!) time. Also, check to tubes for any grid leakage. This tends to play havoc with AGC tubes. This isn't the chassis with a solid state IF, is it?
|
|
#2
|
|||
|
|||
|
I did check for grid emissons on all tubes, one of the 6JT8 subs I had was real bad and it was NOS I grabbed another NOS and it was fine, but screwed up the AGC, thats when I put the old weak one back in.
The 3rd IF tube was nearly dead, replaing it brought back a strong video signal (it was very washed out even with agc adjusted), but still has the super critical AGC. when I have the scope out checking the collector of the noise gate I will also check other AGC stuff, generally I look for the flyback pulse, video signal, and the filtered output to the RF and IF circuits (in case the filter cap was open, but I checked that so don't think its the problem). I will check that coupling cap you mentioned, I presume a DC voltage check would find that. Its all tube but for that one noise gate transistor. |
|
#3
|
|||
|
|||
|
hmmm that cap is a 4.7pf from the sound IF detector and does not look like a voltage check would work to check it. I will check it later after scoping the keying circuit, esp the fly pulse at the plate since that was causing havoc with the strong Keying tube. there is a 68pf that couples the horz pulse that I have heard can cause issues, but nver ran into a bad one yet.
|
|
#4
|
|||
|
|||
|
tried another 6JT8 NOS same deal, touchy sync. that's about all I can do in the short term, next up is the scope.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|