![]() |
|
#7
|
||||
|
||||
|
I tend to work on older sets so take this advice with a grain of salt, but I think it is a good SOP to test tubes before first power up to prevent future headaches.
I always try to keep tubes in mind during trouble shooting as they can conk out at the most confounding times. To illustrate this I have a Silvertone roundy that I tested the tubes and got a poor raster on before repair. I had to change some parts in the horizontal oscillator and messed up it's frequency. Well that set likes to eat damper tubes (by way of shorting) when ever the horizontal frequency is too far off. It took me months after the original work to figure out that it had killed the original damper. After all of that I decided to go through the horizontal adjustment procedure and discovered that when I had momentarily ran the set with the horizontal frequency off it had eaten another damper! This set also conked out again a while back due to the damper loosing emissions to the point of testing marginally after prolonged warmup (it would test at the lower end of good as soon at it warmed up, but slump soon after).
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
| Thread Tools | |
| Display Modes | |
|
|