|
I wrote a bit about this earlier. It is indeed caused by cheap modulators. You mentioned the line shifts with the adjustment of the horizontal hold control. The line is caused by ringing in the video chain and the falling edge of horizontal sync overshoot or color burst during horizontal retrace will show up as faint line(s).
A cure is to repair if included, modify or add a horizontal retrace blanking circuit. This would involve coupling a pulse from the horizontal flyback to the video path to the CRT. Often you will find the vertical retrace blanking is included: adding horizontal retrace blanking is somewhat similar.
Another solution as suggested is to get a better modulator or modify the video going to it to minimize the overshoots. Broadcasters years ago were very careful to ensure their video did not cause this problem. With modern sets, less attention is paid to the video because newer sets blank the CRT during horizontal retrace!
|