![]() |
|
#27
|
||||
|
||||
|
Quote:
This is what I have done. Using clip leads I inserted a 1K 50 watt wire wound pot into the power supply circuit. The best place to insert the droping resistor is on either one of the leads of the power supply choke. I chose this location because it is the best place to insert and have the droping resistror effect all of the various power supply voltages. While adjusting the 1K 50W pot, I monitored the B+ supply voltage and when I reached 350V (the specification on the Sams schematic) I recorded the voltage across the pot and the current through the pot. I dropped 72 volts and had 440ma currrent. I calculated about 32 watts of heat energy will be generated. Then I disconnected the pot and measured the resistance. 150 ohms. I have ordered some Vishay 50W 150 Ohm Aluminum clad power resistors from Mouser. Mouser Part# 71-RH50-150 at $4.67 each. I will mount the resistor somewhere on the top of the chassis where the heat will be easily disipated. If you want to go with the 380v B+ as specified in the RCA print, then these values are what you will need. 70 ohm 20 watt, gives me 380v B+ in my set. My set seems to be functioning about the same at either B+ voltage. I get a nice full bright raster at either 350v or 380v. If you replace the original stack rectifiers with 1A 1000piv diodes I would guess you will need to drop a similar amount of B+ voltage to get the supply voltages back within specification. Good luck, and I will post the photos of the mod in a couple of weeks after the new resistors arrive and I install them, so you can see how I did it.
__________________
Vacuum tubes are used in Wisconsin to help heat your house. New Web Site under developement ME http://AntiqueTvGuy.com Last edited by ohohyodafarted; 03-14-2012 at 12:48 PM. |
| Thread Tools | |
| Display Modes | |
|
|