Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #10  
Old 02-08-2012, 12:46 AM
Einar72's Avatar
Einar72 Einar72 is offline
Chasin roundies since '79
 
Join Date: Jan 2006
Location: Federal Way, Washington
Posts: 936
Replace ALL caps you still have jumped. You DOUBLE the value when two caps are in parallel. Check the resistors in the vertical circuit very carefully, remove one end before you measure unless it dead-ends by itself to a tube-socket pin. It's a Catch-22 either way you go, heating one end when removing it (or replacing caps) can change the value either temporarily or permanently. If a resistor changes value appreciably when heated, it's probably bad anyway. Measure the voltage up and down the B+ divider as well, if everything else fed after the Vert stage is low as well, that may indicate a problem. It's been 20+ years since I worked on mine and I just can't recall the schematic...
Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:54 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.