Philco Predicta 9L37 chassis horizontal output tube red plating.

[Dangler]

I don't have a scope anymore, I sold pretty much of all my test equipment when I retired from the repair service. About all I have left are some digital and analog VOM's and a cap checker. Looking at the Sam's, it looks like the grid of the horizontal output tube is connected by a 3,300 mmf cap from pin 6 of the 6CG7 horizontal oscillator tube. Am I on the right track? Also, would 3,300 mmf translate to .033 uf ? I'm going to check it in a couple of minutes. Thank's for the help so far. Dan.