![]() |
|
|
|
#1
|
||||
|
||||
|
Ok, pulled the SAMS (100-1) and ammending my above, You disable the AFC by removing plate voltage from V14 pin 2. (Disconnect the wiper on the horiz hold control) adjust the HORIZ FREQ for a single image. This is a Synchroguide type circuit, and the adjustment procedure can be found on the web.. (Usually, they start with jumpering the sinewave coil, in this case jumper across R72)
|
|
#2
|
||||
|
||||
|
Line up vertically: does that mean the pictures are lined up in a vertical row one on top of another or are the multiple pictures lined up horizontally side-by-side?
|
|
#3
|
|||
|
|||
|
About 4 or 5 lined up side by side. Also I need to have the tuner slightly between the channel indents to pull the station in. Sounds like alignment issues?
|
|
#4
|
||||
|
||||
|
Quote:
There are detailed instructions in the Riders service info for adjusting the horizontal oscillator and horizontal lock controls also sample waveforms if you have a scope. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|