![]() |
|
|
|
#1
|
||||
|
||||
|
I also have this same set, using a 17BP4, and has the little bump on the set back. Mine had a burned up power transformer, due to someone trying out the set in the past. I found the shorted capacitor on the first hunt, and aquired a transformer and chassis from a nice fellow in Rhode Island.
I've replaced a bunch of electrolytics in mine, so far, and now have sound thru the Inputuner to the speaker, and FM radio, clear as a bell! I'm running the set after each capacitor replacement, and was thoroughly surprised when the sound came on... full volume... due to the volume being up all the way... after a single capacitor replacement under the deflection circuitry area of the set. Still no picture, but I think I am hearing the vertical oscillator running... I'm not letting the HV come up, yet. My set has the tube number on the underside of the CRT bell up near the screen. Last edited by holmesuser01; 10-21-2011 at 02:28 PM. |
|
#2
|
||||
|
||||
|
Well unfortunately my CRT is not looking too promising. I’m getting a solid reading now, but it’s way towards the bottom of the bad scale. Even with the filament voltage at 8v, emission only rises to about 1/3 scale. Dropping the filament voltage back down, the emission takes a nose dive. I'll let it cook a couple days and see if it improves.
I think we’re to the point that we may have to get creative and start subbing newer CRT’s in our old sets, at least if we want to continue watching them on a regular basis. I’ve seen a couple NOS 17CRP4 available, but those are 90 degree electrostatic focus and they have a very low g2 voltage spec. I suppose they could be adapted to if we’re not too fussy about original circuitry. |
|
#3
|
||||
|
||||
|
My 19AP4 was a rebuilt tube with an October 1964 label on it. I therefore had hope that it was good.
When I got the set home and tested it with my BK467, there was absolutely no emission. I tried coaxing it back to life and the emission improved slightly but was miserably low. I then gave the tube a rejuvenation burst. Lo and behold the emission came right up and is now excellent, even on life test. This was a few weeks ago and I tested it again and the emission remains excellent. Consider that the tube has been sitting dorment for probably forty years. I think it just needs to be woken up. |
|
#4
|
||||
|
||||
|
Quote:
VDC actually shows 17BP4's in stock, most likely in error. I've inquired about other tubes and they're not really there. http://vdc.mybisi.com/product/17bp4 Last edited by Kevin Kuehn; 10-21-2011 at 07:37 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|