![]() |
|
|
|
#1
|
||||
|
||||
|
You may be able to get by on the CRT reheating the solder on the pins, and glueing the original base back together.
If you can get knobs, but not doors you could always take the remaining door off, and either leave it that way or make/get new ones for a semi-permanant solution.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#2
|
||||
|
||||
|
I decided to pull the broken CRT base off. Everything seems to be still in tact under there. I tinned the leads and soldered on strands of wire to use as pigtails, in order to pull the wires through the pins on a new base. I cleaned up a base from a useless series string brightener. Made a dry run before mixing epoxy.
Last edited by Kevin Kuehn; 10-21-2011 at 01:13 AM. |
|
#3
|
||||
|
||||
|
I mixed up some black epoxy and stuck the base back on the neck. I have a table leaf leaning against it until the epoxy sets. I used 30 minute epoxy so I'll probably have to wait till morning for it to get good and hard.
Last edited by Kevin Kuehn; 10-20-2011 at 08:00 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|