![]() |
|
|
|
#1
|
|||
|
|||
|
thought I was on to something, a 3uf cap that connects to the base of the horz afc transistor thru a 1.5k resistor was open. Replaced it. I think its function was to smooth the voltage from the horz phase detector diodes, but not sure about that.
Next up will be to replace both horz phase diodes AND both 100k resistors that are connected in P with them. The sync is solid, I am only checking replacing these as I have read up on horz pos problems associated with the AFC diodes. Charles, I hope you can find something in your documentation, I have both the sams and goodman service manuals, could not find any reference to how to adj the horz posistion. |
|
#2
|
|||
|
|||
|
hmmm I have a shorted saw tooth shaper transistor on the horz module. getting late will see what I have tomorrow.
|
|
#3
|
|||
|
|||
|
could not wait of course, found a generic NPN silicon in my junt box motorola 306, popped it in (thank you zenith for the plug in transistors) bingo horz centered.
This shaper transistor was a grounded base transistor that took the horz pulse from a winding on the FLY and used coupled it to the AFC diodes. |
|
#4
|
|||
|
|||
|
What is the zenith part number and the actual numbers on the transistor?? I have lots of that stuff and should be able to find one.
Good job on that one, usually when transistors it results in smoke and or multiple other parts destroyed. |
|
#5
|
|||
|
|||
|
its an ECG123a. I am going to stop by the local surplus store, they have lots of old transistors.
Yea what threw me was the lack of other problems, just a little bit of horz postion (about 2" to the right), everything else worked perfect so like you I assumed the transistors were ok. was getting ready to replace the AFC diodes, checking them in circuit they looked ok. As long as I had the diode tester I did a quick sweep of the 4 transistors in circuit. When that one did not check I figured it was just a part shunting the BC, pulled it and tested again. I suppose if I had checked the voltages or waveform on that with the set running I would have seen it. anyway its all back together now. 121-447 GE-20 motorola HEP736 SK3124 ECG123a |
| Audiokarma |
|
#6
|
||||
|
||||
|
Quote:
Mine has also survived a house fire, two severe earthquakes throwing it on the floor, and being moved countless times. Charles
__________________
Collecting & restoring TVs in Los Angeles since age 10 |
|
#7
|
|||
|
|||
|
couple more things, its still slightly off center, much better with the replacement transistor but still not right. I notice it the most when using one of the different zoom levels from the converter box that allows for less than full screen view.
I have the correct transistor on the way (as oppposed to a NPN that I just had on hand). Other things I plan to do is replace the 2 100k resistors on the AFC diodes. they are spec at 100k 5% actual values (tested in circuit so not sure if this is accurate, need to look over the schematic again) 112 and 117 so pretty close match, but I will replace anyway with some match ones that are 100. AND will go ahead and replace the two AFC diodes. again this is more just an exercise in cause and effect than any actual needed repair as I suspect it may be working within allowable tolerances. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|