![]() |
|
|
|
#1
|
||||
|
||||
|
So just to be clear, your set has all five of the white ceramic "crt-neck-snapoff" caps replaced with the orange 22-5001 special caps? If not, you're in jeopardy of hearing "ZZZZZZZZZZZZZZ-pffffffsssshhhhhhhhhhhhhhhhT!!!!" followed by the smell of ozone and the sound of glass powder tinkling down onto the chassis...
As far as the width goes, I can't remember how it's adjusted on that set. I do have all the manuals and supplements on it, but I'm in Dallas this week and they're in California, so I'll look it up next week if you need. Charles
__________________
Collecting & restoring TVs in Los Angeles since age 10 |
|
#2
|
|||
|
|||
|
Charles, I only recall seeing three replaced, two were on the Flyback topside, and one was one was on the bottom, all the 22-5001 orange drops. I did not see any white caps remaining.
I hope you can find something to adj either the centering or the width, its shifted way off the right, although I think its more centering than width since round objects to not seem like they are overly wide. |
|
#3
|
|||
|
|||
|
just sitting here watching football, those CC2 zeniths just make a GREAT pic, the color really is stunning. all I can say if everybody needs to save one for their daily driver. When I had the back off the other day I check the PT caps and the fly, all stone cold after extended running.
|
|
#4
|
|||
|
|||
|
somewhere I read that horz AFC diode can still work for sync but cause a centering problem. think I will check those out.
|
|
#5
|
|||
|
|||
|
the horz hold control does move it some, but not enough, and it never breaks sync even at the extreme end of the control. odd, its a coil but seem to have very limited travel. I cant see an external limit stop like on older zeniths where its built into the knob. Of course there is prob something inside the chassis. I only get about 180 degrees of adjustment so there has to be something.
Last edited by DaveWM; 10-10-2011 at 07:04 PM. |
| Audiokarma |
|
#6
|
|||
|
|||
|
before I mess with pulling the horz module, any hints on pulling it? I assume you just gently pull up, but dont want to break anything. the module is a 9-57
|
|
#7
|
|||
|
|||
|
thought I was on to something, a 3uf cap that connects to the base of the horz afc transistor thru a 1.5k resistor was open. Replaced it. I think its function was to smooth the voltage from the horz phase detector diodes, but not sure about that.
Next up will be to replace both horz phase diodes AND both 100k resistors that are connected in P with them. The sync is solid, I am only checking replacing these as I have read up on horz pos problems associated with the AFC diodes. Charles, I hope you can find something in your documentation, I have both the sams and goodman service manuals, could not find any reference to how to adj the horz posistion. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|