![]() |
|
|
|
#1
|
|||
|
|||
|
youtube vids?
|
|
#2
|
||||
|
||||
|
I finished a total recap and replace many out of spec resistors.
I added a 220 ohm resistor to one leg of the focus pot to compensate for the shorted windings in the damaged area. ![]() The linearity is pretty good. The horizontal is off a little (squares on the left are wider than on the right), but the linearity adjustment coil doesn't have much of an effect. ![]() Here's a multi-burst bandwidth test at 0.5, 1.5, 2.0, 2.5, 3.58 and 4.2 MHz. Curious that the middle bars (2.0 MHz) are less distinct. I suspect the IF has a pronounced double hump response. ![]() part 1 part 2 Still working on part 3. It will cover alignment. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|