Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early Color Television

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #9  
Old 10-01-2011, 04:41 PM
ctc17 ctc17 is offline
VideoKarma Member
 
Join Date: Jul 2009
Posts: 1,615
The little plastic gear is about 1/4 inch, it kinda sticks down in the tuner. Its the gear that actually engages and turns the tuning slug in the tuner bars. You will see a nipple on the end of the shaft that slides into a slot in the tuner, be very mindful of the gears location on the shaft. It has to be in EXACTLY the right spot or it wont engage properly.
Use some lacquer thinner or acetone to clean the grease up. Get the grease out of the gear by rolling a small piece of paper towel up and dipping it in solvent. You will see the shaft is ribbed, the ribs must be grease free. JB Weld works well, let it dry for 24 hours.

I have done about 8 of them now, will make a video next time sense its such a common problem. It takes patience and a little skill.

Dont stress over color, its basically the same with a few more circuits. And its a bit more critical that everything works right, like this fine tuning issue. Very good chance that will fix your color when you can fine tune the set.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:22 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.