![]() |
|
|
|
#1
|
||||
|
||||
|
I remember an oddball 12" B&W Magnavox that must have been one of their last tube sets. It had a vertical osc/output tube (IIRC, 17JZ8) and a horizontal output/damper tube (IIRC, 38HE7). It used a solid state "stick" HV rectifier and it had a couple of modules for the sound and IF.
I also had a 12" Motorola "handle on the side" B&W set that claimed it was "solid state" on the front; however, it had some sweep circuit tubes in it. I guess that one was a "friday job". The first RCA and Motorola solid state color sets still used an HV rectifier tube and I've seen many solid state B&W sets that still had a tube for the HV rectifier. I think the Philco Safari and the '60's era Sony portable B&W's used several subminiature tubes in an HV multiplier circuit. |
|
#2
|
|||
|
|||
|
The poster that indicated that GE made tube type Portacolor sets until 1977 is correct. I have a couple.
|
|
#3
|
|||
|
|||
|
I also have both GE and Sylvania solid state B&W TVs from around 1965. The GE uses high voltage diodes(3 in series) for the HV rectifier, so is truly solid state. Not sure about the Sylvania.
I just replaced the horizontal output transistor on the Sylvania. I was afraid that the flyback had went, but once the shorted transistor was replaced, it seems to work fine. I also have some small later 1960s Philco/Ford B&W sets that are solid state except for the HV rectifier. |
|
#4
|
||||
|
||||
|
i have owned several dated 79 and seen at least one 80
__________________
i collect and restore vintage radio's,tv's,and ham gear. email for more info |
![]() |
| Thread Tools | |
| Display Modes | |
|
|