![]() |
|
#2
|
||||
|
||||
|
Look on the FP-746 "mode control" board
You should have heater voltage (between 2-4v outer pins -ac or dc on the flourescan) and a negative voltage around -30vdc to drive the grid (check pin53 on IC 102). Often times the grid voltage goes missing due to a failure in the regulated supply or IC. Also check to see that you're getting +5 and -5v regulated, and that the 8mhz clock is running on the display processor (pin 5,6 IC102). Otherwise the display mode controller won't work and you'll get no display either. Machine works otherwise?
__________________
Jordan |
| Thread Tools | |
| Display Modes | |
|
|