![]() |
|
#26
|
||||
|
||||
|
Time to tackle the old, melted CRT mask. Most of it peeled away. I then used water and a small brush to work the rest loose.
Yummy ![]() ![]() Here's the new reproduction mask installed. ![]() The original brown paint had mostly flaked off the bottom. I recently read a tip that the Rustoleum "camouflage" series works well for cabinet bottoms, backs and insides. First, I removed the feet and masked off the cabinet and label. Then, sealed it with shellac and sprayed on a couple light coats. It's very flat and I think looks pretty good. ![]() The rest of the cabinet is just about done too. I think one more round of 1000 grit sanding and a final coat of semi-gloss lacquer will do it. What I did was patch the veneer chips and lightly sand the top layer of the old finish. Then fill in the voids with lacquer sanding sealer. Finally, put on a few coast of semi-gloss lacquer. My goal was to retain the original patina, but fix up the biggest flaws and protect it. ![]() If you're wondering why the remote controls to the right are upside down - it's so they don't scratch my vintage coffee table
Last edited by bandersen; 08-19-2011 at 10:53 PM. |
| Thread Tools | |
| Display Modes | |
|
|