Time to get this site upgraded, so we are passing the hat around. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html
We appreciate your help
in keeping this site going.
They label the 6L6 "horiz osc," but perhaps it only does output. In an old Milton Kiver book, I found a circuit (first scan) very similar to the one in the 661-P's horizontal/AFC subchassis (second scan). They both follow the general scheme shown in the 661-P functional diagram (third scan).
If I understand correctly, the sync signal arrives at the 661-P's horizontal/AFC subchassis through pin 3 of the adapter plug. One half of the 6SN7 amplifies the signal, which is compared by the 6AL5 to the output of the 6K6 local oscillator. The 6AC7 control tube corrects the frequency. The signal passes to the second half of the 6SN7, and then to the 6L6 output tube through pin 7 of the adapter.
Or something like that. In any case, my scope shows a sawtooth at pin 2 (plate) of the 6SN7, which goes to the grid of the output tube. Not the hump-and-peak waveform you get in a synchroguide circuit, but it makes a very stable picture, all the same.
Kind of a bare-bones system, otherwise: no damper, no horizontal linearity control, no drive control. The linearity isn't great, but I'm not going to worry about that until I've worked on the HV level and width some more.
Phil Nelson
Last edited by Phil Nelson; 07-26-2011 at 07:28 PM.