![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
OK, I must be wrong then. Let me know how that works out for you. ![]() You still have a luma delay, don't you? What do you think that does to the coincidence of luma and chroma at the CRT? Trust me, it's not as simple as removing the luma delay, either. There are time shifts happening in the luma channel as well as chroma, if you don't do anything it's not gonna end up at the same place at the same time.
__________________
Evolution... |
|
#2
|
||||
|
||||
|
Quote:
I'll try again! ............The DVD player outputs R-Y as rP and B-Y as bP in perfect time registry with each other and the luma/sync as Y. The DAs that make the Y, rP and bP have responses well greater than 5MHZ at the DVD outputs. If the three coax cables leading to the CTC2B monitor are matched, perfect time registry is retained as they enter directly into the new Component to RGB converter piggy-back boards. The analog processing on these converter boards uses all ultra high speed SS video op-amps spec'd at 400mhz, 400V/us, 25ns rise time.The only signal the original CTC2B works on is the Y luma/sync and this goes direct to the sync separators and retrace blankers no place else. The RGB videos from the converter boards go directly to the original red, green and blue full BW CRT driver board's first stage grids. So is the possibility for time registry errors existing at the CRT socket real? I think not. Last edited by Tomcomm; 07-25-2011 at 06:20 PM. |
|
#3
|
||||
|
||||
|
Quote:
![]() It would seem to me this may be a recipe for alias artifacts. Then again, I may be wrong. I would consider filtering at least to ITU R601 specifications eg approximately 5.5 MHz for luma and 2.75 MHz for chroma. ![]() Terry |
|
#4
|
||||
|
||||
|
Quote:
__________________
stromberg6 |
|
#5
|
||||
|
||||
|
That last post got screwed up in sequence, but I think you get the message.
Kevin
__________________
stromberg6 |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|