![]() |
|
|
|
#1
|
||||
|
||||
|
Made in 2006 it may be a generation or two after the Light Engine fiasco.
Does the set look good when it is working, no color blobs or patches? If it does then the LE is probably OK, or at least it doesn't suffer from the problem that a lot of them had. I doubt a bulb would be intermittent unless the set can sense it's getting tired. Perhaps the contacts where the bulb is inserted are burned up or dirty. Could be dust blocking the air passages and overheating it, these are cooled with a fan. It wouldn't hurt to take a look, and yes, a bulb is something the consumer can, and was expected to change every so often. I don't know how it's done on your set but there should be a removable panel on the bottom, either in front or back. New ones are less than $100 these days http://cgi.ebay.com/REPLACEMENT-BULB...item23127a063e |
|
#2
|
||||
|
||||
|
Also, wear rubber gloves when handling the bulb.
Skin oils tend to shorten their lifespan because they run quite hot. |
|
#3
|
|||
|
|||
|
The picture looks good when I have seen it. There were no botches in it. She told me it is not as bright as it used to be. I didnt notice a fan running when I looked at it. Will the bulb cause it to shut down?
John |
![]() |
| Thread Tools | |
| Display Modes | |
|
|