![]() |
|
|
|
#1
|
|||
|
|||
|
From the "thought i'd seen it all" department, this has gotta be the first problem I've ever seen caused by the HV being too high in a BW set. Color sets, yes. But never a BW before this one.
![]() Anyhow, if adjusting the horiz. drive hasn't reduced the HV sufficiently, it's easy to cut back the gain of the output tube itself (the 6AV5). One method is to put a resistor in series with the cathode (say 100 ohms as a ballpark starting value). The other is to reduce the screen grid voltage (on pin 8). This is the method I would try first. Assuming you don't have a resistor decade box or a resistor assortment on hand, go to RadioShack (ugh ) and get a card of 2.2K half-watt resistors. Locate the 5.6K screen grid resistor R84. Open one leg and insert a 2.2K resistor in series with it. Bring the set up and see what the HV reads. This will give you a ballpark indication of which way to go with R84, ie., whether it needs more resistance or less. If it needs more, add another 2.2K in series. If that's too much, you can make a 1.1K by paralleling a couple of the 2.2K. The caveat is, if you succeed in getting the HV down and the arcing cured with the set at full line voltage, the width may be reduced too much. I'm betting the width will still be sufficient. If it's not, then a new plan of attack is in order. oc |
|
#2
|
||||
|
||||
|
Quote:
![]() ![]() . Granted there is no video, the horizontal isn't linear, and the screen is full of retrace lines but I'm pretty happy to be at this point . ![]() Just some questions/concerns at the end here. Horizontal size and Horizontal linearity control slugs do nothing to the screen when adjusted. Can some one tell me what Horizontal Drive and Horizontal AFC are/do? |
|
#3
|
|||
|
|||
|
Well son of a gun. Fancy that.
First of all, is your set the version with the 'color converter socket' and "color switch" (M7)? If so, clean the heck outa that switch with contact cleaner since it's in the video signal path and could be killing the video if it's dirty.**Also if the set has a phono input and a TV-phono switch (M6), good idea to clean that switch too while you got the squirt can going. Quote:
AFC= automatic frequency control. One section of the 6SN7 (V15) serves the AFC function while the other section is the oscillator. **Just like the 'service switch' in color sets. Ask Phil about that. ![]()
Last edited by old_coot88; 07-06-2011 at 09:09 PM. |
|
#4
|
|||
|
|||
|
While i share your disgustipation with RS on several levels, in many places they remain the only walk-in source of small parts like resistors, caps, fuses etc. ever since local parts houses went the way of the dodo bird. I grudgingly have to patronize RS pretty regularly. oc
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|