![]() |
|
|
|
#1
|
|||
|
|||
|
use a HV probe to monitor the CRT anode voltage
is the HOT red plating? wiggle the HOT and the horz osc tubes. hold a neon bulb near the plate cap of the HOT (I have one mounted to a small plastic stick). I would pull the HOT plate cap off, check for B+, if that checks then I would put it back on and check the HOT grid for about -50v, screen voltage of around 150v. Also check the cathode current of the HOT. This is where a tv analyst like a B&K 1076 comes in real handy. |
|
#2
|
|||
|
|||
|
you cant check the focus stick like a reg diode. You can just check the focus pin of the CRTwith either a meter like a simpson 260 on the 5kv setting or just a reg HV prob, the same as used in the CRT anode. Check to see around 5kv
|
|
#3
|
||||
|
||||
|
Quote:
|
|
#4
|
|||
|
|||
|
I would try a new HV rectiifier tube, assuming the HV is not present.
|
|
#5
|
||||
|
||||
|
I'll give that a shot, though I just replaced it with a NOS one last night.
Last edited by fsjonsey; 06-30-2011 at 05:18 PM. |
| Audiokarma |
|
#6
|
||||
|
||||
|
Bingo. The "new" one i installed yesterday must have been a dud.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|