![]() |
|
|
|
#1
|
|||
|
|||
|
sweet. cool cabinet. are the reds weak or is it just the programming (looks a bit weak to me)?
|
|
#2
|
||||
|
||||
|
It's the lighting and my iPhone camera. CRT tests strong on all three guns.
|
|
#3
|
||||
|
||||
|
Well, I have a problem. Went to turn on the set this morning, and a raster never appeared. I can hear some HV whine and audio, but nothing else. The set played fine all last night. Where would be an obvious place to look for a problem like this? I checked the HV rectifier, horizontal output tube, and damper, all tested fine.
|
|
#4
|
||||
|
||||
|
Can you hear the high voltage "crackle" when it comes up? If so, look for the video output tube and see if it is lit. I have a similar chassis, different model that gives a nice picture.
Also, check your focus rectifier. I am not sure but on some sets no focus voltage can cause no raster. |
|
#5
|
||||
|
||||
|
Quote:
|
| Audiokarma |
|
#6
|
|||
|
|||
|
use a HV probe to monitor the CRT anode voltage
is the HOT red plating? wiggle the HOT and the horz osc tubes. hold a neon bulb near the plate cap of the HOT (I have one mounted to a small plastic stick). I would pull the HOT plate cap off, check for B+, if that checks then I would put it back on and check the HOT grid for about -50v, screen voltage of around 150v. Also check the cathode current of the HOT. This is where a tv analyst like a B&K 1076 comes in real handy. |
|
#7
|
|||
|
|||
|
you cant check the focus stick like a reg diode. You can just check the focus pin of the CRTwith either a meter like a simpson 260 on the 5kv setting or just a reg HV prob, the same as used in the CRT anode. Check to see around 5kv
|
|
#8
|
||||
|
||||
|
Quote:
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|