Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 06-21-2011, 09:03 PM
tubesrule's Avatar
tubesrule tubesrule is offline
VideoKarma Member
 
Join Date: Jul 2004
Location: Michigan
Posts: 331
Dave,
Pre-war crt's are made from Pyrex and are very tough, but should be treated as any crt, with care. The best way to test them is in operation. You can of course at least check for a good getter and filament. These crt's use a 2.5V filament.

The crt is not actually loose in the set but is held in place inside the cardboard sleeve which is held by braces at the top. The rubber mask on top and wood escutcheon holds the crt down. If you do want to remove it, take the center wood escutcheon off (screws in the back and wing nuts towards the front), very carefully remove the socket and HV lead, and lift the crt AND cardboard sleeve straight up and out of the cabinet. You will be lifting the crt neck out through the yoke, so be careful not to put any undue side force on the neck. Just lift straight up.

You can see what the 12AP4 crt and cardboard sleeve look like here:
http://www.myvintagetv.com/picture_tubes.htm

Darryl
__________________
Converters for obsolete standards:
www.tech-retro.com/aurora-design/legacy.html

Last edited by tubesrule; 06-21-2011 at 10:02 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:38 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.