![]() |
|
#16
|
||||
|
||||
|
Quote:
With our test jig (a old RCA metal cabinet 22" set), we'd pull the chassis, swap the fly, tubes, and give the HV cup a good cleaning. After an adjustment of the horizontal efficiency coil and a couple hours run time, it was back to the customer's house where we cleaned the CRT anode, adjusted the HV, and set focus and check the convergence. The repairs ran just over 150 bucks, with the bulk of the cost being tubes and the fly. Back then, it was flat $24.50 color labor, and no service call charge if the chassis was pulled. We'd do this several times a month. I hated it when Maganvox sets ate flybacks - no jig, so the heavy set got pulled, and I was the proverbial 98 pound weakling back then.... Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! |
| Thread Tools | |
| Display Modes | |
|
|