![]() |
|
|
|
#1
|
|||
|
|||
|
What dave said on the tuner, but I usually slide the cracked gear off, clean it up really good and jb weld it back on the ribbed shaft. Every zenith I own has that gear cracked.
How was the cutoff on that crt? Were you able to get up to high in the red? What kind of emission do you get at 5 volts? (i have the same crt tester) That red and green color bleeding can be caused by a semi week crt. |
|
#2
|
|||
|
|||
|
Quote:
![]() my 20Y1C38 in the early 90s and no problems with the tuning mechanism. Worked great.
|
|
#3
|
||||
|
||||
|
Thanks everyone for the guidance. You guys are spot on about the tuner. I'll disassemble it and do it right. As for the CRT, I'm afraid it is on the weak side. I couldn't get the red channel up to the "gun bal" line on the meter so I don't know how valid the emissions test is. The green and blue guns seem OK. I didn't test the CRT specifically at 5 volts, but emissions dropped pretty rapidly on the life test. So, I'm not sure how much effort I want to put into this set if the CRT tired. On the other hand, it is making a very watchable picture that seems to be getting better all the time. I do have an old Heathkit C-3 cap checker that I can use.
I may not have much time to work on this set for a few weeks, but I'll post my progress when I do. Thanks again for the help, Clark |
![]() |
| Thread Tools | |
| Display Modes | |
|
|