![]() |
|
|
|
#1
|
||||
|
||||
|
Cliff,
Just out of curiosity, has anyone ever played around with superimposing DC onto the AC which supplies the field windings of the AC motor. It is my recolection that if you place DC onto the windings of an AC motor it will act like a magnetic brake. Perhaps, the speed could be controlled by varying a DC component in the field coils of the AC motor. Just a thought, I have no idea if it is even a viable idea.
__________________
Vacuum tubes are used in Wisconsin to help heat your house. New Web Site under developement ME http://AntiqueTvGuy.com |
|
#2
|
||||
|
||||
|
Quote:
The recent post showing the wheel set on Jim Hawes website uses two motors to spin and regulate the wheel speed. There are pictures showing the mechanical configuration. This is the set I showed at ETF in 2006. The main motor has AC applied through a rheostat and spins the wheel slightly faster than it's synchronous speed. The second motor is coupled to the shaft of the main one and has only a varying DC voltage of about 8 volts applied to it from the servo amplifier. The DC varies across the second motor acting as a dynamic brake to slow the wheel and keep it spinning in sync and in phase with the red field I.D. pulses so the picture is correct. I used this method to sync this first wheel set I ever built because I had a very difficult time making the saturable reactor servo work. I got the idea for using the second motor from a technical book on VTR and VCR circuitry. When I get some time, I'll investigate simultaneous application of AC and DC to a motor and find out if it might work for wheel sets. I know this will work with a universal motor, one with field coils and a wound rotor with brushes and a commutater, but so far I've used only split phase-capacitor run induction motors in the sets I've built. The one thing I've never done is to build a set using a DC motor with a phase lock loop chip like the 4046 or a pulse width modulated servo. I still have much to learn... #;^) Cliff |
|
#3
|
||||
|
||||
|
Quote:
The film had sync windows down the middle that were sensed by a fiber light pipe source shining through onto a phototransistor that triggered the SCR, so the SCR itself was the phase detector between the trigger pulse and the phase of the AC line. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|